Flashing

XS ++

This tool is quite straightforward to use. First off, you’re going to need the main firwmare, the filesystem for that firmware and a customization pack, which should be available for your phone in the “Files” section.

Upon launching the tool, you should see this screen:

To put the phone into recovery mode, you should now remove your phone’s battery, put it back in, hold the C key while connecting the phone to the computer and click “Connect”

Once it’s done, you’ll have a screen that looks like this

Now you have to supply your main firmware (.mbn) file, and your filesystem in the corresponding sections. For the customization pack, you need to unzip it in a folder next to your XS++ executable called own_custpack. Once done, the own_custpack folder should only contain a folder called tpa.

Before flashing, the tool should be in this state

Now, click flash and wait for it to finish flashing (it should take around 5-10 minutes)

Once done, remove your phone, remove its battery, put it back and power it on.